MET/CAL procedures

Your instrument, your standards, your MET/CAL procedure

I write MET/CAL verification procedures from the manufacturer’s manual, for your own standards and MET/CAL setup (version 11.3.1 or higher). Manual, remote, or both.

What you receive

A procedure built for your lab, with a source for every value.

Built for your lab

Written for your standards, accuracy files and MET/CAL configuration.

Manual or remote

Manual, automated via GPIB, USB, LAN or RS-232, or a combination of both.

Every value has a source

A test-point plan with the source of each value. Values without a document are marked UNVERIFIED.

Complete files

MET/CAL Editor files in one archive, with a change log that states the source of each value.

How it works

From your request to a validated procedure, in six steps.

Step 1

Send your request

Tell me the instrument, your standards and your MET/CAL version, using the form.

Step 2

Questions and quotation

I ask about the scope and send a quotation, valid for 30 days, with a secure upload link for your .acc and .ini files.

Step 3

Order confirmation

The agreement starts with my order confirmation. 50% is invoiced then, and I start after payment.

Step 4

Test-point plan

Functions, ranges, test points, tolerances and standards, each with its source. I write the procedure only after your written approval.

Step 5

Delivery

You receive the procedure files and change log. The remaining 50% is invoiced on acceptance.

Step 6

Test and validate

Report defects within 10 business days. I correct them free of charge up to 20% of the original time, and also within one month of delivery.

Good to know

What to expect before you order.

You validate

Validate the procedure under your own quality system, and ISO/IEC 17025 where it applies, before use. I accept no metrological responsibility.

Your lab tests

I do not have your standards or your instrument. I compile and review the procedure; your lab tests it on the real equipment.

Independent of Fluke

These are not Fluke Calibration procedures. Support for them comes from e-Consilio.

Use within your group

You may use the procedure in all calibration labs of your organisation.

AI-assisted tools

I use AI-assisted tools in my work. Tell me before ordering if your organisation does not allow this.

Where

Customers worldwide, except the United States and sanctioned territories.

Payment

By bank transfer, or through the online payment link on the invoice.

Terms

Our terms and conditions apply, including Module A for MET/CAL procedure development.

An instrument without a procedure?

Send the make and model, your standards and your MET/CAL version. I reply with questions and a quotation.